4 product(s) found for "Darth Vader Costume Accessories"
  • Darth Vader Chest Box Coin Slots.  ANH..
    Darth Vader Chest Box Coin Slots. ANH..
    £2.50
    This was one of those quite by chance parts, when it was pointed out to me the same coin slots were used on both R2D2 and Darth's chest box, but on the chest box it seems there were two versions. The ones in ANH have a lip around them, while the ones in ESB and ROTJ are missing the lip, or some people claim it's just been painted black, so six of one and half a dozen of the other, so I have done two versions, this is the ANH version with the lip, so it's up to you. This is for a set of 3 coin slots...
    Details
  • Darth Vader Chest Box Coin Slots. ESB ..
    Darth Vader Chest Box Coin Slots. ESB ..
    £2.50
    This was one of those quite by chance parts, when it was pointed out to me the same coin slots were used on both R2D2 and Darth's chest box, but on the chest box it seems there were two versions. These are the ESB and ROTJ version which is the one without the lip, however it should have a red centre where the slot is, which can be seen glowing in the film and the easiest way I have found to do this is 3mm clear red plastic sheet and just cut tiny bits to fill the slot, then place a flashing LED behind....
    Details
  • Darth Vader Helmet Vents Type 1
    Darth Vader Helmet Vents Type 1
    £10.00
    I was given one of the actual metal vent parts which was taken from a Thorn EMI photomultiplier tube in 2006 by a fellow star wars fan who wanted to know if I could duplicate it in resin. These are perfect copies of the original, which it seems are nigh on impossible to get hold of these days, so while perhaps not as prestigious as the proper metal ones, they do the job and look just the same when painted. I now also do these as just the square vent section, as it was brought to my attention some...
    Details
  • Darth Vader Helmet Vents Type 2
    Darth Vader Helmet Vents Type 2
    £7.50
    I was given one of the actual metal vent parts which was taken from a Thorn EMI photomultiplier tube in 2006 by a fellow star wars fan who wanted to know if I could duplicate it in resin. This version is just the centre square vent part, as it was brought to my attention some moulded fibreglass head shrouds have just a little square recess not a hole so just cast up the middle leaving off the surround. I also do these as perfect copies of the original with flange, which it seems are nigh on impossible...
    Details
Product Added to your Cart
x

-------- OR --------